Any assembly line equipment is composed of three parts: the power part, the line body support part and the electrical control part. When the assembly line equipment suddenly presents problems or fails to work properly, it will lead to the production line stopping production and affect the efficiency of the factory. Therefore, fault diagnosis and repair must be carried out. So how to judge the line equipment fault? The following is introduced by the operation staff of the assembly line manufacturer:

Pipeline equipment

1. Check all power supply and electrical control equipment of assembly line equipment.

Problems with power supply and electrical control equipment often lead to problems with assembly line equipment. For example, the power supply presents problems, including the whole workshop power supply problems, such as low power, insurance burned, power plug contact poor; Whether the electronic components in the electrical control box, such as sensors and relays, work normally, whether the line interface is in bad contact or not, any part of the problem may cause the assembly line equipment to stop running. All loops should be checked to see if the wires in the circuit appear to be broken, especially if the wires in the grooves are cut by the grooves because of pulling.

2. Check the power part of the assembly line equipment.

Because of the neglect of equipment protection personnel, perhaps the transmission motors and frequency converters of some assembly lines will lead to problems because of long-term operation. These important components should be regularly protected and maintained, etc., and fault needs should be investigated one by one and handled in time. Belt conveyor line

3. Check the transmission part and line body support of the assembly line equipment.

The transmission part includes driving drum, adjusting drum, bearing, sprocket and so on. The fault will lead to the phenomenon that the belt of the assembly line may run off or be stuck. These parts may also appear loose or sliding with the vibration of the assembly line equipment, which is required for daily protection in the automation equipment.